​​
ioTouch Board:
​
-
ESP32-WROOM with dual-core Xtensa® 32-bit LX6 MCU, 16MB flash
-
WIFi 802.11 b/g/n (802.11n up to 150 Mbps) 2.4 GHz ~ 2.5 GHz
-
Bluetooth v4.2 BR/EDR and BLE specification
-
FT813 EVE2 video engine co-processor with 1MB dedicate Graphic-RAM, 24bit RGB interface, capacitive touch engine, audio engine, and PWM backlight output.
-
USB connector with UART transceiver for autonomous boot and very useful for monitor purposes.
-
Smart power management with an internal switch to power from 5V (USB /external on FFC) or a Battery with enable pin.
-
Integrated dimmerable LED driver to control the display backlight .
-
FFC connector to expose all ESP32 usable pin (except ones used by internal flash), USB, enable pin and FT813 audio output.
-
All in 47x57mm dimension enables you to use it from 3.5" to 5.0" displays.
ioTouch Discovery :
​
-
Interface with ioTouch board trough 40Way FFC connector (cable included).
-
A secondary USB connector helps to make the MCU accessible in desktop/tablet-like applications.
-
A little speaker with a dedicated audio amplifier is connected to the ioTouch GPU.
-
On board lypo charger and solderable pad (battery not included).
-
MicroSD connector lets you cover all your storage needs (sd card not included).
-
A micro switch to control the enable pin and power ON/OFF the device also while connected to an USB power source...
-
professional SLM 3d printed frame to build a desktop/tablet-like device.
-
RGB led bar to make wonderful visual signals and animations.
